IU22 L15-7io Linear Array Transducer For Intraoperative Vascular

L15-7io Linear Array transducer

Form Factor: Linear Array
Applications: Intraoperative, Vascular
Frequency Range: 7.0 - 15.0 MHz.
Compatibility: IU22

Other Philps probes we can offer:

Warnings and cautions of ultrasonic probe

★The ultrasonic probe is a valuable device. It must be careful in the process of use. Avoid dropping, impact, or abrasion to transducers.

★When installing or removing the probe, first switch off the power and then operate it carefully.

★Avoid rapid and extreme temperature changes, as well as lengthy exposure to direct sunlight or a strong ultraviolet light source.

★Do not use sharp objects to penetrate the acoustic lens.Once the acoustic lens is damaged, the coupling gel is easy to enter the interior of the probe and damage the piezoelectric element.

★Do not soak transducer in any liquid above the recommended level as stated in the user manual for your system, please operate according to the manufacturer's instructions, otherwise it will lead to circuit failure or even burn out.

★Do not disinfect at high temperature, because the probe is equipped with piezoelectric ceramics, high temperature will weaken the effect.

★Before use, carefully check whether the housing and cable are damaged, so as to prevent the probe from high voltage injury.

★After the probe is used, the residual coupling gel on the probe must be wiped clean to prevent rats or other animals from gnawing the lens.

Storage for Transport of ultrasonic transducer

1. Make sure that the transducer is clean and disinfected before placing it in the case to avoid contaminating the foam that lines the carrying case.

2. Place the transducer in the case carefully to prevent kinking of the cable.

3. Before closing the lid, make sure no part of the transducer is protruding from the case.

4. Wrap the case in plastic material containing sealed-air pockets (such as Bubble Wrap material), and pack the wrapped case in a cardboard carton.

Daily and Long-Term Storage of ultrasound transducer

Extend the life of your ultrasound probe with these simple tips.
Let’s face it, having to replace an ultrasound transducer can be extremely costly. Especially if you are buying them directly from a manufacturer. The good news is, by following the proper handling protocol and using the right probe disinfectant, you can extend the life of your ultrasound probes. We put together some simple tips to keep in mind and help ensure your probes are being handled with care.

Ultrasound Transducer Care Tips

Cleaning: Do not allow prolonged exposure to excessive moisture or immersion of transducers in any liquid above the recommended level as stated in the user manual. Do not soak transducers in any liquid for longer than the recommended period according to the chemical manufacturer instructions for use. Always refer to the manufacturers user manual or guide for cleaning and disinfecting probes. DO NOT use abrasive paper products when cleaning or wiping probes.
Storage: Always store transducers in the holders located on the side of your system (for console systems). Hang probe cables appropriately on the system cable drapes. Probes can be stored on a securely mounted wall rack. Make sure your transducer holders are clean before storing.

IU22 L15-7io Linear Array Transducer

Linear Array Transducer For Intraoperative

IU22 L15-7io Linear Array Transducer For Intraoperative Vascular Images